What are the main application industries of wastewater evaporator?

Main features of wastewater evaporator:

1. The entire heating system of the equipment has the main features of high heat transfer efficiency and short heating time due to the uniform steam heating and liquid film flow evaporation. If equipped with a hot pressure pump, it will have the advantages of reduced consumption, low steam consumption and low water circulation.

2. The material accelerates the pressurized flow and evaporation downward along the inner wall of the tube, adapting to the evaporation and concentration of material liquids with higher viscosity.

3. Since the material evaporates into a film in each tube, the heating time of the material liquid is very short, so it is especially beneficial to the evaporation and concentration of food, and the nutrients of the food are preserved to the maximum extent.

4． The evaporation process is under the action of vacuum, which not only ensures the hygienic requirements of the material, but also greatly reduces the evaporation temperature. In addition, with the hot pressure pump, part of the secondary steam is re-inhaled through the hot pressure pump to mix with the raw steam, which saves raw steam. At the same time, because the steam passing through the hot pressure pump enters the heating shell in the form of spray mist, the steam diffuses rapidly and the material liquid is heated gently, so it is suitable for the concentration of heat-sensitive materials.

5. The equipment is suitable for evaporation and concentration of foaming materials. Since the material liquid evaporates into a film in the heating tube, vapor-liquid separation is formed. At the same time, most of the material liquid is pumped away at the bottom of the effect body. Only a small part of the material liquid and all the secondary steam enter the separator to strengthen the separation. The entire process of the material liquid does not cause much impact, avoiding the formation of foam.

6. For food evaporation and concentration, when the temperature reaches above 94 degrees and is maintained for about 24 seconds, it enters the first effect body. The material flashes quickly and the temperature drops instantly.